NEWS
customized Small shaft supplier
Author:
Source:
Release time:
2022-03-15
Customized Small Shaft Supplier for Engine , A heat-conducting plate is installed on the inner side wall of the shaft sleeve, and self-lubricating bearings are fixed inside the shaft sleeve on both sides of the heat-conducting plate. The stop block, and the angle between the adjacent stop blocks is one hundred and twenty degrees, the side of the stop blocks away from the self-lubricating bearing is welded with springs, and the two ends of the rotating shaft are provided with dust covers , the edge position of the dust cover away from the shaft sleeve is installed with a fixed ring. The utility model not only prolongs the service life of the customized Small shaft supplier for the engine, improves the performance of the customized Small shaft supplier for the engine, but also Improved the convenience of using customized Small shaft supplier for engines.
The above is a brief introduction to the relevant knowledge about the customized Small shaft supplier for engines.
Small,shaft
Related News
2026/08/24
2026/08/20
2026/08/16
2026/08/12
2026/08/08
Follow us